I have a Gateway (GM) MFATXPNT ESX 500. I would like to know how to remove the casing so I can remove the hard - Answered by a verified Tech Support Specialist. Molpoints Keygen Idm. Looking for drivers for the Gate way Desktop 500S Gateway Appenetly doesnt have this model in. The Complicated Way to Install Gateway ESX 500S Drivers. Open the computer and Search the official website of Gateway. Call iYogi at 1 8 to get the best technical support by our Certified Technicians for installing Gateway ESX 500S drivers. Gateway.com Support. Gateway 500X To comment on this article and other PCWorld content, visit our Facebook page or our Twitter feed. Gateway 500X.

This 500X desktop was working fine when I stored it about 8 months ago. Just reconnected it last night. When I power on the mouse never lights up and the monitor immediately goes into power saving mode.

I have powered off and on Changed USB slots for the mouse All with no results. Seems I would have problems in the past when I would put computer in sleep mode and wake up it would not recognize the mouse and monitor would go to power save but if I did a hard boot it would work ok. The monitor shows it is getting signal but only will go to power save mode. How do you know the power supply is the problem? What issues are you experiencing? Have you done any trouble shooting first?

It could be a bad hard drive. If you should need to replace the power supply first you need to get a you can get here. The next step is to unplug the computer from the wall >remove the case side access panel >so you don't fry *********** board electronics from static electricity discharge which can cost you a lot more to replace >now disconnect the plugs from the power supply wire harness, it may help to count the connections and mark them with a piece of tape or draw a diagram so you don't forget which loose cables should get reconnected to the new power supply. There will be at least one that connects directly to a plug on the mother board, DO NOT put tape there.

>Next remove the screws which mount mount the power supply to the metal frame and slide out the power supply >slide the new power supply in the same way the other other was removed (note top from bottom) and then screw back to frame and reattach the cables >close the case >remove your grounded wrist band >plug computer back into wall and start the computer. Congratulations, you have just replaced your power supply and ready to go. IMPORTANT: Do not switch the power output selector switch on the power supply. Usually a recessed re switch which will adjust for european vs. US power input conversion.